Anchor Navi-Trac Lite Manuel d'instructions d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Anchor Navi-Trac Lite. Anchor Navi-Trac Lite 20 pages. Frame tent 30' wide system

Imprimer la page

COMPLETING THE HIP END

UPPER FRAME

In the following steps the upper frame of the hip end will be

completed (see fig.13 to the right). Following this sequence

will result in a smooth assembly.

As this upper frame is completed, you should begin to position

the hip end close to its intended position.

In addition to the long and short pins used above, the corner

weldments have a thicker short pin that is used only for hori-

zontal pinning through the lower end of the hip bar.

END EAVE

E-15

Complete the end eave by joining each

Eave Bar (E-15) to the Eave Weldment

(EW), as shown, and pin with long pins.

HIP

CORNER

E-15 (SIDE)

The free ends of the Eave Bars used to pivot the

cross beam can now be attached to the Corner

Weldments and pinned vertically with a long pin.

(R-30)

Install the upper end of each Hip Bar to the ridge weldment at the top of

the cross beam. To do this, first align the Hip Bar straight in along

side the Rafter w/ Hook, then swing the lower end of the Hip Bar out-

ward to the Corner Weldments and pin with the short, thick pin.

Insert a square arm of a Corner Weldment

(CW) to each outer end of the Eave Bar (E-

15) as shown and pin with a long pin.

E-15 (END)

(H-30)

(RH-30)

INSTALLING HIP BARS (H-30)

E-15

END EAVE

(RH-30)

(R-30)

Using the Rafter w/ Hook (RH-30) and the Eave Bars (E-15)

for leverage, pivot the cross beam to a vertical position, lin-

ing up the Eave Bars with the Corner Weldments at each

end of the end Eave Bar assembled in the preceding steps.

(RH-30)

(R-30)

The free lower end of the Rafter w/ Hook can be

attached to the Eave Weldment (EW) at the center

of the end eave. Secure vertically with a long pin.

H-30

Close-up of the Hip Bar (H-30) connection to the

Corner Weldment (CW). Notice the slotted underside

of the hip bar designed to drop over the top arm of the

Corner Weldment.

PIVOTING THE CROSS BEAM

E-15

(END)