AirTech 3AV130 Instructions de réparation - Page 7

Parcourez en ligne ou téléchargez le pdf Instructions de réparation pour {nom_de_la_catégorie} AirTech 3AV130. AirTech 3AV130 10 pages.

Repair Instructions 3AV 30 - 430

Reassembling and Adjusting Impeller

2.3

Install impeller on motor shaft

Coat the disk of impeller with liquid seal (Epple)

Install washer on the coated disk of impeller

Thread on nut to impeller adjusting screw

Adjust impeller with the impeller adjusting screw. There should be a gap of 0.1 – 0.15 mm between the

surface of the impeller and the surface of the shaft seal housing. Use the metal straightedge and the

feeler gauge to adjust the gap.

Block the impeller if the gap is correct. Tighten nut of the impeller screw.

Turn impeller. There should be no contact between impeller and shaft seal housing and also no con-

tact between impeller and metal straightedge. If there is any contact re-adjust the impeller.

2.4

Coat shaft seal housing (411) with liquid seal (Epple)

Install inter casing on shaft seal housing. Correct position of inter casing is given through the pins at

shaft seal housing