Electrolux CHDI 8610 Instructions d'utilisation et d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Electrolux CHDI 8610. Electrolux CHDI 8610 20 pages. Cooker hood
Également pour Electrolux CHDI 8610 : Manuel d'utilisation et d'installation (24 pages)

Imprimer la page

Control device for grease and charcoal filters

This hood is fitted with a device that signals when it is necessary to clean the grease filter

or the charcoal filter (in the case of recirculation version with charcoal filter).

On delivery, the hood is not supplied with an charcoal filter, so the saturation indicator will

be disabled.

If the hood is to be used with a charcoal filter, the saturation

indicator light must be enabled as follows:

Press buttons B and G simultaneously and hold them for 3 seconds. At first only the

grease filter LED D will light up, but when the charcoal filter LED E lights up the saturation

indicator will be enabled.

To disable it: Press buttons B and G again simultaneously and hold

them for 3 seconds, until the charcoal filter LED goes out.

Grease filter LED (D)

LED D will start to flash when it is time to clean the grease filter.

Cleaning will be necessary after 40 working hours. Always comply with the maintenance

instructions for the grease filter.

Charcoal filter LED (E)

The charcoal filter LED E will start to flash when the charcoal filter needs to be replaced.

This operation is necessary after approximately 160 working hours.

Resetting the saturation indicator

After cleaning or replacing the filters, press button A for 3 seconds until the grease filter

LED D or the charcoal filter LED E stops flashing.