en
Causes of damage
]Causes of damage
G eneral information
C a u s e s o f d a m a g e
Caution!
Accessories, foil, greaseproof paper or ovenware on
■
the cooking compartment floor: do not place
accessories on the cooking compartment floor. Do
not cover the cooking compartment floor with any
sort of foil or greaseproof paper. Do not place
ovenware on the cooking compartment floor if a
temperature of over 50 ºC has been set. This will
cause heat to accumulate. The baking and roasting
times will no longer be correct and the enamel will
be damaged.
Aluminium foil: Aluminium foil in the cooking
■
compartment must not come into contact with the
door glass. This could cause permanent
discolouration of the door glass.
Water in a hot cooking compartment: do not pour
■
water into the cooking compartment when it is hot.
This will cause steam. The temperature change can
cause damage to the enamel.
Moisture in the cooking compartment: Over an
■
extended period of time, moisture in the cooking
compartment may lead to corrosion. Allow the
cooking compartment to dry after use. Do not keep
moist food in the closed cooking compartment for
extended periods of time. Do not store food in the
cooking compartment.
Cooling with the appliance door open: Following
■
operation at high temperatures, only allow the
cooking compartment to cool down with the door
closed. Do not trap anything in the appliance door.
Even if the door is only left open a crack, the front of
nearby furniture may become damaged over time.
Only leave the cooking compartment to dry with the
door open if a lot of moisture was produced whilst
the oven was operating.
Fruit juice: when baking particularly juicy fruit pies,
■
do not pack the baking tray too generously. Fruit
juice dripping from the baking tray leaves stains that
cannot be removed. If possible, use the deeper
universal pan.
Extremely dirty seal: If the seal is very dirty, the
■
appliance door will no longer close properly during
operation. The fronts of adjacent units could be
damaged. Always keep the seal clean. Never
operate the appliance if the seal is damaged or
missing. ~ "Cleaning" on page 16
Appliance door as a seat, shelf or worktop: Do not
■
sit on the appliance door, or place or hang anything
on it. Do not place any cookware or accessories on
the appliance door.
Inserting accessories: depending on the appliance
■
model, accessories can scratch the door panel
when closing the appliance door. Always insert the
accessories into the cooking compartment as far as
they will go.
Carrying the appliance: do not carry or hold the
■
appliance by the door handle. The door handle
cannot support the weight of the appliance and
could break.
6
5Installation and connection
T his appliance is only intended to be fully fitted in a
I n s t a l l a t i o n a n d c o n n e c t i o n
kitchen. Observe the special installation instructions.
Do not install the appliance behind a decorative door or
the door of a kitchen unit, as this may cause the
appliance to overheat.
Electrical connection
Only licensed specialists may connect the appliance.It
is important that you comply with the requirements of
your electricity supplier.
Any damage arising from the appliance being
connected incorrectly will invalidate the warranty.
Caution!
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
The appliance must be disconnected from the power
■
supply whenever installation work is being carried
out.
The appliance fulfils the requirements of protection
■
class I and may only be connected to an earthed
socket.
The mains power cable must be at least type
■
H05 V V-F 3G, 1.5 mm².
:
Warning – Danger of death!
There is a risk of electric shock if you touch live
components.
Always make sure your hands are dry when you
■
touch or hold the mains plug.
Only pull out the mains cable by taking hold of the
■
plug and removing the plug; never pull it out by the
mains cable itself, as this could damage it.
Never unplug the mains plug when the appliance is
■
in operation.
Please note the following information and ensure that:
Notes
The mains plug fits the socket.
■
The cable cross section is adequate.
■
The earthing system is properly installed.
■
The mains cable is only replaced by a qualified
■
electrician (if this is necessary).Spare mains cables
can be ordered from our after-sales service.
No power strips/multi-way connectors or extension
■
cables are used.
If using a residual current device, only use one that
■
bears the mark
.
z
The presence of this mark is the only way to be sure
that it fulfils all the applicable regulations.
The mains plug can be accessed at all times.
■
The mains cable is not kinked, crushed, modified or
■
severed.
The mains cable does not come into contact with
■
heat sources.
Imprimer la page