Atlantic PV1700 Manuel d'instruction - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Atlantic PV1700. Atlantic PV1700 16 pages. Oasis series skimmer, filterfalls, pump vault, fastfalls
Également pour Atlantic PV1700 : Manuel du produit (12 pages)
Oasis FastFalls Installation
SETTING THE SP1600
Place the Oasis FastFalls on a level bed of undisturbed soil if possible, to avoid settling. If
installing above existing grade, compact the area thoroughly. This critical step will ensure
that the FastFalls will not settle out of level over time. Blocks or bricks set on virgin soil can
also be used to raise the FastFalls while reducing the chance of settling.
Place the FastFalls right at the pond's edge to create a single dramatic fall, or pull the
FastFalls back from the edge to create a stream. Leave plenty of liner around the FastFalls to
make it easy to camouflage with rock later.
To ensure a leak-proof installation, test
place the FastFalls in the desired
location and level it from side-to-side
and front-to-back. The closed design of
the FastFalls ensures that water will only
exit the unit over the spillway, so there is
no need to tilt the FastFalls forward.
When you are satisfied with the
placement of the FastFalls, remove
the unit and install the liner and
underlayment, being careful not to
disturb the level base. Place the
FastFalls on top of the liner in its original
position. Check the unit for level to
ensure that nothing has changed. Once
the FastFalls is level and positioned correctly, place a couple of large stones on top of the
FastFalls. This will ensure that the FastFalls does not move when backfilling and attaching
liner (Figure D).
LINER AND PLUMBING ATTACHMENT
Hold the liner up against the flat panel on the back of the Oasis FastFalls enclosure. Leave
some excess slack in the liner below the spinweld. This will help alleviate any future strain on
the liner connection. Make sure the back surface of the FastFalls, and the back side of the
liner is clean and free of debris. Once you are satisfied with the position of the liner, lower it
down and prepare to apply the silicone sealant (Figure E).
Figure D.
Figure E.
13