Atlas TSD-PA10VG Manuel du propriétaire - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Atlas TSD-PA10VG. Atlas TSD-PA10VG 8 pages. Mono 10w commercial power amplifier
Également pour Atlas TSD-PA10VG : Manuel du propriétaire (8 pages)

Imprimer la page

Mono Commercial Power Amplifier

Rear Panel Description

TSD Input/Output connections are removable for easy system wiring. The connectors have a 3.5mm

pitch between pins.

1. DC Power Input - Each TSD that requires DC power comes with a 2 position connector for an

external 24VDC power supply (sold separately). Because of the TSDs low power consumption, a

single external power supply may power more than one TSD. Please refer to the specifications

on current requirements in milliamps to match with the appropriate power supply. Please observe

the polarity of the wiring to this connector. Note: It is acceptable to exceed the current

requirements of the TSDs but NOT safe to use a power supply that is below the current

requirement of the device.

2. Balanced Line Input - Connect balanced line level signals to the phoenix style connectors. Your

connection must be mated properly to the input connector or signal loss and/or noise may occur.

Note: Unbalanced line level inputs can also be used by connecting the (G) and (-) terminals

together.

3. Speaker Outputs - Connect the loudspeaker wiring to these terminals, observing the polarity

shown on the rear of the chassis. For low impedance loads, use the "COM" and 4Ω terminals.

For high impedance loads, use "COM" and the proper terminal for your system (25/70/100V). It is

recommended to keep the sum total of tapped loudspeakers to 10W.

4. Output Load Switch - For 8Ω & 4Ω loads place the switch into the 4Ω position. For 25/70/100V

speaker systems place the load switch into 25/70/100V position. Failure to do this may cause the

amp to go into protect.

5. Cable Management Retainer Points - Use the rear panel screws for connecting the included cable

retainers. Each TSD comes with two cable retainers for simplified cable management.

AtlasSound.com

TSD-PA10VG

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

– 4 –

Specifications are subject to change without notice.

Owner's Manual