Atlas PM8CX Manuel d'instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Atlas PM8CX. Atlas PM8CX 7 pages. Pedant mount loudspeakers 4" and 8"
Également pour Atlas PM8CX : Manuel d'instructions d'installation (12 pages), Brochure (2 pages), Fiche technique (3 pages), Manuel d'instructions d'installation (19 pages)

Installation Via Mounting Cables (Included)

General considerations and hardware recommendations

CAUTION: PM series models weigh as much as 21 pounds (7.9kg) – model PM8CX. A fall from almost any height could result in serious injury

or death. Assure that the speaker is firmly mounted to an object that can handle the weight of the PM speaker. The mounting surface the PM

speaker is being attached to should be able to handle five or more times the weight of the PM speaker

The hardware employed must be safely and securely attached both to the loudspeaker and the structure in question, using only the mounting

holes. A general rule for soft surface installations (wood beams) is to multiply the corresponding working load limit by 75%: the result will be

approximate working load strength. Use thread locking compound for all installations.

CAUTION: Mounting the PM loudspeaker may require two people.

When in doubt contact a qualified structural/mechanical engineer for approval of the mounting materials and methods.

1. R emove the 3 top cover mounting screws, loosen the 2 side top cover screws rotate the top cover counterclockwise, and pull up to remove

the top cover. (Fig 1 and 2)

2. Locate suitable support structure in the area the speaker is to be installed.

3. R oute the bare end of the main support cable though the included clamp, then around the mounting structure, and back through the clamp.

(Fig 3 and 4)

4. Adjust the cable length in the clamp so that the eyelet end of the cable is at the final height above the floor. (Fig 5)

5. ( For PM8) Route the eyelet end of the main support cable through the top cover of the PM speaker, attach the included carabiner clip to

the eyelet and the large mounting hole on the back of the PM speaker. (Fig 6a) (For PM4) Route the eyelet end of the main support cable

through the top cover of the PM speaker, attach the eyelet to the large mounting hole on the back of the PM speaker using included

mounting screw. (Fig 6b)

6. R epeat steps 1-4 for the safety cable and attach it the one of the smaller mounting holes on the support plate of the PM speaker with the

included mounting screw. (Fig 6)

7. Route the speaker cable through the top cover and connect to the appropriate terminals.

8. P osition the top cover over the side cover screws and rotate the cover clockwise to align the top cover mounting screw holes. Reinstall the

3 mounting screws, tighten and tighten the side cover screws.

9. S lide the top hole plug over the main support cable, safety cable, and speaker cable using the opening on the side of the plug. Then slide

the plug down the cable and into the top cover hole. (Fig 7 and 8)

Note: If the speaker is being installed outdoors, seal plug with RTV silicone to prevent moisture from entering speaker.

1601 JACK MCKAY BLVD.

ENNIS, TEXAS 75119 U.S.A.

PM Series

Pendant Mount Loudspeakers

TELEPHONE: (800) 876-3333

FAX (800) 765-3435

2/7

AtlasSound.com