ABSCO SHEDS ADGAZEBO63 Manuel - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ABSCO SHEDS ADGAZEBO63. ABSCO SHEDS ADGAZEBO63 14 pages. Signature gazebo

DOWNPIPE

Check and clean swarf from surfaces. Swarf will rust and if not cleaned away can permanently

Absco Industries

Assembly Instruction Manual

ABSCO SIGNATURE GAZEBO

MODEL: ADGAZEBO63

6.12m W x 3.11m D x 2.60m H

NOTE: The method shown is to mount a simple

full height straight downpipe RWG21. An 80 to

90 mm adapter RWG29 is supplied if you wish to

join into existing system instead.

1. Fit both downpipe clips RWG23 to the

centreline of the post at the positions shown.

2. Fasten the clips to the posts using tek screws

Add this tek as

FAST100 (no neoprene washer).

per 3 on page 7

Be careful not to over-tighten and damage.

Predrilling may be helpful.

3. Cut the downpipe to length.

4. Place the dropper RWG22 into the top of the

downpipe and fasten and seal, press into clips

and slide up until it touches the underside of the

gutter.

5. Straighten and then mark the four fastening

holes and the centre.

6. Cut out the centre hole with a 70 mm hole saw.

7. Seal the dropper to the underside of the gutter

and rivet at all corners.

8. Secure downpipe to clips using two tek screws

FAST100 (no neoprene washer). Be careful not to

over-tighten and damage.

Immediate maintenance required!

discolour the structure.

Model: ADGAZEBO63

4/12/23

1.00