3M XT-1 Bulletin technique - Page 5
Parcourez en ligne ou téléchargez le pdf Bulletin technique pour {nom_de_la_catégorie} 3M XT-1. 3M XT-1 10 pages. Drive-thru systems
Également pour 3M XT-1 : Manuel de référence rapide (6 pages), Manuel de référence rapide (2 pages), Données techniques (2 pages), Bulletin technique (2 pages), Manuel de démarrage rapide (3 pages), Manuel (8 pages)
Replacing Battery Latch Parts (Battery Button, Battery Latch, or Battery Latch Spring)
and /or Battery Holder PWA (Printed Wiring Assembly)
Replacing Battery Latch Parts
Tools Required:
1 - Number 0 Phillips Screwdriver
1 - Tweezers
1 - Small size Phillips screwdriver
3M OEM Parts and SKUs:
Procedures:
1. Make sure power is off and remove the battery from the headset. See Fig 16.
2. Disassemble the battery housing side of the headset by removing
screws as shown in the illustration. See Fig 17.
3. Carefully separate the two halves of the housing. See Fig 18-a.
4. Holding the battery half of the housing in one hand, carefully separate
the Battery Latch from the Battery Latch Button. See Fig 18-b.
NOTE: It may be necessary to compress the two retainer posts on
the Battery Latch Button to release the Battery Latch.
5. Remove and set aside the two pieces that make up the button/latch assembly.
6. Locate the spring in the housing and remove it using a tweezers or
equivalent tool, to grasp and lift the spring up and away from the housing. See Fig 19.
7. Replace any broken Battery Latch parts (Battery Button, Latch, or Spring)
and reassemble onto the battery housing performing steps 1-6 in
reverse order.
FIGURE 19
Battery Latch
Battery Latch Button
Battery Latch Spring
FIGURE 16
FIGURE 17
FIGURE 18-a
Battery
Battery half
Cover
of housing
FIGURE 18-b