247Security mDVR600 Series Manuel rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} 247Security mDVR600 Series. 247Security mDVR600 Series 14 pages.

CAMERA CABLES

Camera Cables (available in lengths of 15, 35 or 50 feet) use the STP (shielded twisted pair) cable standard. The

Camera Cables are connected using molded 2x3 Molex interfaces that are keyed to prevent improper mating. Each

connector uses a clip to snap securely to each camera and to the inputs on your DVR. The camera cables snap in

place with the cable clip facing towards the base of the DVR. After the installation, all Camera Cables should be

concealed and holes filled with grommets to protect the equipment from vandalism.

EVENT MARKER

The Event Marker is used for the driver to indicate a critical event during recording, which the DVR will interpret as a

priority video for later review. When the driver presses the event marker button, the DVR will mark all video feeds

from 150 seconds prior to and after the button press, 150 seconds is the factory default, but is programmable from

1 – 600 seconds. These priority event videos can be retrieved by the technician, using our USB memory stick, to be

viewed on a computer with the DVRViewer application installed.

The 600Series is unique in that an Event Marker is also built in to the front of the DVR and can be used in

conjunction with or in place of the external Event Marker cable.

The Event Marker module has one button, to signal an event, and 3 color lights to indicate three DVR states: green

for POWER; amber for hard drive RECORDING; and red for VIDEO LOST when a camera signal has been lost.

POWER CABLE

A three-wire, 12-feet-long Power Cable is used for connecting the DVR directly to the battery power in the vehicle's

electrical box. The cable uses a large molded 2x2 Molex connector that is keyed, thereby connecting to the DVR in

only one orientation. The cable's three wires are described in the following table:

POWER CABLE

DC IN (Red)

GND (Black)

IGN. ON/OFF (White)

Two screws (#4 thread, 3/8" long) are included to securely fasten the Power Cable to the DVR. Securing the Power

Cable to the DVR prevents occupants from deactivating the system by disconnecting the Power Cable.

IMPORTANT:

Make sure that both the RED (constant power) and white (ignition power) are fused in the electrical

box with 7.5 Amp fuses (not supplied).

247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com

BUS ELECTRICAL PANEL

Constant LIVE Power Source (battery side of solenoid, direct current)

Ground in bus electrical panel

Ignition-switched Power (live only if ignition is turned to ON/ ACC)