ANSITE AST-2008D2 Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} ANSITE AST-2008D2. ANSITE AST-2008D2 10 pages.

if the main set received the alarm signals from detectors, it will alarm if set no delay time,but

if you set a delay time for guard,for example 30 seconds, setting guard will take into effect

only after 30 seconds later from the time you pressed the

normally left for you to prepare to exit your house entry.

Fig.2 Setting panel illustration

Fig.3 Remote controller illustration

*withdraw guard setting by remote controller:

Press and release

will go out ,the main set went into status of withdraw guard. At this time, if the main set

received the alarm signals from all detectors of zone 1,2,3,4, it will not alarm.

2. setting guard by pressing keypad on the main set

*Setting guard on the keypad:

When not in alarm state,press four digits user password consecutively (for example: "1234",

ect),then press key "set" ,then press digit "

up ,the main set went into status of setting guard. At this time if the main set received the

alarm signals from detectors, it will alarm at once or delayed for a period of option

time(0~90s),

* withdraw guard on the keypad

Press four digits user password consecutively, then press key set,then press digit 0, the main

set went into withdraw guard, in this state, if the main set received the alarm intruder signal

from the detectors , it will not alarm , but if it received trigger signal from the panic button of

the remote controller, it will alarm and dial out telephone numbers automatically.

3. Open or close a guard zone alarm

Each of the four guard zone can be opened or closed, if a guard zone is closed, the main

set will not report out alarm signal from the guard zone received.For example ,if a PIR

detector or door contacts is set belong to guard zone 3,when this detector emit signal to

the alarm main set, the main set zone 3 will not report signal out even in guard state,but

other detectors belong to other zones will be working as usual..

*withdraw guard setting:

When not in alarm state, press four digits user password consecutively (for example:

"1234", ect),then press key "set" ,then press digit "

will go out ,the main set went into status of withdraw guard. At this time if the main set

received the alarm signals from detectors of zone 1,2,3,4,, it will not alarm.

When in alarm state,simply press four digits user password on the keypad will cancel guard

key on the remote controller, the "GUARD"LED on the main set

9",

the "GUARD" LED on the main set will light

0 ",

key. This delay time can be

the "GUARD" LED on the main set