DSC PC1550 Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} DSC PC1550. DSC PC1550 12 pages. 4 digit master code
Également pour DSC PC1550 : Manuel d'instruction (17 pages), Manuel d'instruction (17 pages), Manuel d'instruction (17 pages), Manuel d'instruction (9 pages), Manuel d'instruction (17 pages)

break detectors and vibration or shock sensors. When a sensor is in alarm, a

keypad light will be on to indicate which zone is in alarm.

MASTER CODE

The 4 digit Master Code is used for arming and disarming the

system, for programming additional access codes. and for changing other

features. The Master Code will be supplied to you by your installer. All keypad

entries are made by pressing one key at a time and may be changed by you at

any time if the installer selects an option. For additional access codes, see

Programming Additional Access Codes.

ARMING

Close all protected doors and windows and stop movement in areas

covered by motion detectors. If the "Bypass" light is ON, be sure zones are being

intentionally bypassed before arming the system (see Zone Bypassing).

Check to see that the "Ready" light is ON (all zones are closed). The system

cannot be armed unless the "Ready" light is ON. Enter a [4 digit access code]. As

each digit is entered, the keypad sounder will beep. Once the correct access

code is entered, the "Armed" light will come ON and the keypad sounder will

beep quickly. If the access code was entered incorrectly or the "Ready" light was

not ON, the keypad sounder will beep steadily for 2 seconds. When the correct

code is entered and the system is armed, exit through the door indicated by your

installer as the exit-entry door. The exit time may be changed by your installer

(please refer to the Quick-Arm feature).

Arming and Commercial Installations When an Access Code is entered to arm

the system, the bell or siren will sound a short tone to indicate that the system is

being armed. If your security system is programmed to report to a monitoring

station, the keypad will also sound a tone to indicate that the monitoring station

has been advised of the arming of the system. If the system is being armed and

the bell or siren fails to sound, or if the keypad does not sound a tone to

acknowledge that the monitoring station has been advised of the arming, arrange

for service for the system.

AUTO-BYPASS OPTION - HOME-AWAY ARMING

This feature, if

selected by your installer, will allow you to arm your system with any valid access

code and the system will automatically bypass the interior zones. Those interior

zones have been designated as home-away zones by the installer. When

activated, the "Bypass" light will come ON. If you exit within the allowed exit lime,

the system will automatically reactivate the interior zones. This feature is

designed to save the user from ha ving to manually bypass interior zones each

time they wish to arm the system and remain at home. In residential applications

where the system has been armed and the interior zones are automatically

bypassed, the interior zones can be reactivated from a keypad outside the

interior zones protection area (e.g. a bedroom). To reactivate the interior zones,

press [*] then [1] and the ""Bypass"" light will go out.