DSC PC5928 Manuel de démarrage rapide - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} DSC PC5928. DSC PC5928 16 pages. Audio interface module
Également pour DSC PC5928 : Instructions pour l'utilisateur (2 pages)
Imprimer la page
A
U
D
I
To program the function keys, see Programming Section [000] "Keypad Assignment" in your
PC5010 Programming Worksheets.
Function Key Option #15 - General Voice Prompted Help
This feature can only be programmed if the Escort5580 is being used.
When the function key is pressed, the intercoms will perform a Help page. The user must then
press the Page/Answer button on any intercom station to begin the help session with the Escort.
Function Key Option #18 - Identified Voice Prompted Help
This feature can only be programmed if the Escort5580 is being used.
When the function key is pressed, the Escort will begin a help session from the intercom
station programmed as closest to the keypad. In order for this function to operate properly,
you must program PC5928 Section [802], subsection [14] "Keypad Port Assignments."
This function key cannot be programmed for PC55XX LED keypads with software
version 1.0.
3.13
Music Input
The music Input feature allows the user to broadcast an audio input to all other stations. This
feature can be turned on or off using any keypad on the system.
The music input must be wired to any one single port, using an audio signal which does not
exceed 200 mV peak to peak. This would be accomplished by connecting the audio source
to a microphone input (one side of the source to the mic. input and the other side to ground).
The music input must be programmed in the port definitions (enter installer's programming,
section [802], sub-section [01]). Enter the digits [05] in the appropriate port definition.
To turn on the music input, enter user programming [ ][6][Master Code] then press [7] key.
To turn off the music input, follow the same procedure that is required to turn it on.
The music input feature will not function until 30 seconds after being pro-
grammed in the port definition section.
3.14
Voice Verification
When a page is active between two stations, the Do Not Disturb light on each station will turn on while
its microphone is active. This gives a visual indication to each person involved in the page when their
microphone is active. This is a hardcoded feature and does not require programming to be enabled.
The Voice Verification feature will not work until the page has been answered.
Follow the programming procedure outlined in the PC5010 Installation Manual. All PC5928 Programming
falls under Section [802]. To program the PC5928 Audio Interface module enter the following:
Step 1
Enter [ ], [8], [Installer Code] to enter Installer Programming
Step 2
Enter Section [802] for the PC5928 Programming
Step 3
Enter the 2 digit Section number as found in the PC5928 Audio Interface module
Programming Worksheets
O
F
U
Programming
S
E
C
T
I
8
firealarmresources.com
N
C
T
I
O
O
N
4
N
S