AirTime AT12RM Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} AirTime AT12RM. AirTime AT12RM 2 pages. Wall clock

Hanging the clock

The AT12RM Wall Clocks have a specially designed hanging bracket that prevents a simple

upward motion from removing it from the wall. Secure a mounting screw in the desired

location and slide the key hole at the bottom of the hanging track over the screw. Move the

clock right, down and slightly left to secure it correctly.

Normal Operation

In normal operation the clock listens for a synchronization signal 12 times per day (on even

hours at the 58

operation.

Verifying Reception of Last Signal

Press the A button to verify that the clock received the last transmission signal from the ATX

Series master. The LED on the front will flash Green to indicate that the last transmission

was received successfully. If the LED flashes Red, then the last transmission was not

received. This may indicate the Wall Clock is located outside the transmission area.

Start Reception

Press the B button to manually set the clock to "listen" mode. The green LED on the front of

the clock will flash every 2 seconds. When a signal is received from an ATX series master,

the LED will flash every second. The second hand will stop at 12:00 and the minute and hour

hands will rapidly advance to the correct time. (If no signal is received, then verify that your

ATX Series master is transmitting or move the clock to a different, closer location)

Manual Time Setting

Press the B button for 5 seconds until the second hand stops. Press the A button to advance

the minute hand one minute. Hold the A button to rapidly advance the minute and hour

hands. Press the B button when the hands reach the correct time. The clock will start

normal timekeeping operation.

Disclaimer

The information within this document has been carefully checked and is believed to be entirely reliable. However, no

responsibility is assumed for inaccuracies. Lathem Time Corp. reserves the right to make changes to any products herein to

improve reliability, function, or design.

AirTime, Lathem and the Lathem logo are registered trademarks of Lathem Time Corporation. Other product names mentioned

in this manual may be trademarks of their respective companies and are hereby acknowledged.

Warning: Changes or modifications to this product not expressly approved by the party responsible for compliance could void

the user's authority to operate this equipment.

Lathem and AirTime are registered trademarks of Lathem Time Corporation.

minute between 50

and 59

second). The LED will not flash during normal

Document No: USG0086

Revised: 8-19-2011