DANLERS ControlZAPP CZ CESR 10VDC Notes d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Notes d'installation pour {nom_de_la_catégorie} DANLERS ControlZAPP CZ CESR 10VDC. DANLERS ControlZAPP CZ CESR 10VDC 2 pages.

Imprimer la page

DANLERS ControlZAPP CZ CESR 10VDC Notes d'installation

Installation procedure

1. Please read these notes carefully before commencing work. In case of doubt

please consult a qualified electrician. Ensure wires and cables are securely held

within the connection terminals.

IMPORTANT: The CZ CESR 10VDC Control Unit clock battery must be

engaged (ON) prior to installation by switching the RED dip switch (see

diagram D) to the DOWN position.

2. POSITIONING: The CZ CESR 10VDC switch should be installed to achieve correct

coverage of the area, see diagram B. If the photocell override facility (enabled via

ControlZAPP app) is required, the switch must be located above an area where

daylight can give greater illumination than the artificial light. Avoid locating this

product where it is exposed to drafty conditions (exposed lobbies, open ceiling

voids or near fans) or near heat sources. To cover large areas PIRs should be

spaced in a 5 metre grid formation.

3. Disconnect the ControlZAPP device from the circuit before performing insulation

testing of the wiring circuit.

4. Do not connect on a circuit with large inductive loads, as induced spikes may

cause false triggering or damage the device.

5. CZ CESR 10VDC must be connected to its ControlZAPP Power Supply via the

ControlZAPP communication cable provided, for wiring see diagram C.

NOTE: The use of non ControlZAPP connectors may damage the CZ CESR

10VDC device and will invalidate the warranty.

Settings and calibration

NOTE: ALL settings are adjusted by ControlZAPP App as specified in the

ControlZAPP App User Guide (downloadable from the DANLERS website)

including: MODE settings, SCHEDULER settings and photocell settings and

intelligent photocell calibration procedure.

MODE settings include: Detect Movement (enable or disable), Sensitivity, Short

Visit Mode (with timer), Turn ON automatically (Presence detection or Absence

detection), Turn OFF timeout (from10sec to 23hrs 59min 59sec), Respond to

Daylight (enabled or disabled) the calibration process must be run for the intelligent

photocell to work. Delay before ON or Delay before OFF timers, Scene Recall (ON

or OFF).

SCHEDULER settings include:

DAY TYPES (defining times for each of the different Modes to occur).

WEEKLY SCHEDULE (defining which Day Types are assigned to different days of

the week).

EXCEPTIONS (defining exceptions to the schedule such as holidays).

VIEW ON CALENDAR (overview of schedule).

A: Mounting diagram

Knock out mounting

For telejack entry from

holes or pre-drill

above - knock out

pilot holes.

central mounting hole

B: Detection diagram

Strong detection zone

i.e. person moving arm

or walking towards PIR

up to 5m

up to 7m

C: Wiring diagram

CZ CESR 10VDC

100 - 260VAC

50/60Hz

D: Connector diagram

IMPORTANT

Red dip switch (MUST be

switched towards centre of control)

to engage clock battery ON

Power Supply

Telejack connector

Clip telejack into the device

For side entry -

then join device to mounting

knock out side

plate via mounting clips

mounting hole

For optimum coverage

recommended

mounting height: 2.4 to 5m

Secondary detection

zone i.e. person

walking perpendicular

to PIR

control lines

ballast

Optional

other load

Control Unit