Contacta STS-K080-IP Manuel d'installation et d'utilisation - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Contacta STS-K080-IP. Contacta STS-K080-IP 20 pages. Window intercom system
Imprimer la page
Setup Areas
Whilst in engineers mode, there are 3 editable setup areas. You will always enter
setup area 1 first. The green Volume In LED bar will flash to indicate which setup
area you are in.
Setup Area 1:
Maximum Volume Adjustment (LED 1 flashes)
Increase maximum
Decrease maximum
Setup Area 2:
Ducking Adjustment (LED 2 flashes)
Increase
ducking level
Decrease
ducking level
Setup Area 3:
Hearing Loop Drive Adjustment (LED 3 flashes)
Increase drive
Decrease drive
The drive level should be adjusted so the red LED 8 is illuminated only when
there are peaks in the speech volume.
If the amplifier does not have a loop attached, you can turn off the red loop fault
LED 8 by adjusting the drive down to off.
Please note:
•
If the amplifier detects an error in its' settings memory it will restore itself to
factory default settings.
Increase maximum
customer volume level
Decrease maximum
customer volume level
Ducking on
(Vol Out LED 1 illuminates)
LEDs illuminate to
display loop drive
voltage
14