Apogee MA-1 Silver Edition (Mk.II.3) Livre blanc

Parcourez en ligne ou téléchargez le pdf Livre blanc pour {nom_de_la_catégorie} Apogee MA-1 Silver Edition (Mk.II.3). Apogee MA-1 Silver Edition (Mk.II.3) 2 pages. Aptomizer

Imprimer la page

Apogee MA-1 Silver Edition (Mk.II.3) Livre blanc

Aptomizer: White paper

Introduction:

The Rosetta 200 will be the ﬁ rst Apogee

product to include Apogee's newly devel-

oped optimizer: "The Aptomizer". The Apto-

mizer is a digitally controlled analog process

maximizing the recording levels of analog

to digital conversion in music and sound

recording. The result of the procedure will be

an optimal use of the available bit resolution

and therefore produce the best possible sig-

nal to noise ration and the lowest distortion.

The problem:

The word length of any type of PCM conversion dictates the maximum theoretical dynamic

range. For example a 16-bit system allows for 96dB of dynamic range and a 24-bit system for

144 dB. Again, this is the theoretical range; in real life most 24-bit converters do not go beyond

120dB, because of limitations in chip fabrication, analog noise and limited voltage on the power

rails. However, music and sound in general hardly ever need such dynamics. For instance: a full

orchestra's dynamic range does not go beyond 100dB, not to mention the sound system on which

the music is being reproduced.

The catch is not the dynamic range, the catch is in distortion and the signal to noise ratio.

Contrary to analog recording, digital distortion decreases with higher levels. The more bits that

are being utilized, the higher the resolution; the lower the distortion, the lower the ﬁ xed noise-

ﬂ oor. A good analogy for this phenomenon is digital photography; the resolution of the digital

camera determines the detail of the ﬁ nal picture.So an optimal recording level is vital for a high

quality recording.

On the other side of the spectrum, the process of PCM recording is very unforgiving with regards

to "overs". In other words, when all of the bits have been used and the amplitude of the signal

to be converted is higher then the maximum resolution allows, the A/D converter will produce a

series of maximum values, which will be perceived as clipping. This results in massive and very

unpleasant distortion when reproduced.

Any recording engineer has experienced the art of ﬁ nding the proper recording level; high enough

to keep distortion and noise low and low enough to ensure unexpected peaks will pass the con-

version process without clipping. This can be a tedious process, especially when the end product

is a production-master requiring the most optimal levels.

Solutions:

• Automatic Gain Control: This is the "low" end solution. The process adjusts the recording level

based on the content of the material recorded. The disadvantage is the usually slow response

time of this process, resulting in the clipping of peak material and inconsistency in the perceived

loudness of the overall recorded material.

• The use of compressors and limiters:This can work effectively, but these devices do affect the

dynamics and "sound" of the recorded material and increase distortion.

APOGEE ELECTRONICS CORPORATION