Apollo 1500 Manuel d'installation - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Apollo 1500. Apollo 1500 17 pages. Swing gate operator

SYMPTOM

Disconnect the solar panel or charger and measure the battery voltage. Battery should read 12 or more volts and

never drop below 11 volts when gate is operating.

Reset program switches to factory setting. # 1,# 3,# 7,# 8 ON, all others OFF.

Disconnect all accessories from the circuit board - receivers, push buttons, keypads, loops, phones, intercoms, etc.

Activate the operator by momentarily shorting GND to INP

on one of the three pin connectors.

If the operator works, reconnect each accessory individually

starting with push button and test operation.

Disconnect actuator from circuit board and inspect pins in the connector for damage or

poor connections.

Check for proper limit switch configuration (multimeter required) on the connector from

the actuator:

GATE IN OPEN POSITION ....... Orange & Green wires are shorted, White & Green

are open.

GATE IN CLOSED POSITION .. White & Green wires are shorted, Orange & Green wires are open.

GATE IN MID TRAVEL............ White, Green, & Orange wires are open, no shorts.

Replace circuit board.

Gate will not open or close.

RED & WHITE PROGRAM

SWITCHES

1 ON

2 off

3 ON

4 off

5 off

6 off

7 ON

8 ON

9 off

Momentarily short

with a piece of wire

or needle nose.

wires