App-Tek OdaLog Surface-Mount Antenna Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} App-Tek OdaLog Surface-Mount Antenna. App-Tek OdaLog Surface-Mount Antenna 4 pages.

Imprimer la page

PREPARATION:

1. Test Communication:

To check the antenna is working correctly prior to installation, it is recommended to

test connection. Plug in the standard 'stub' antenna - then compare with surface-mount

antenna to ensure your OdaLog connects correctly (refer to OdaLog RTx user manual

for instructions on how to connect to the internet server).

2. Mounting:

The antenna should be mounted on relatively flat surface metal, plastic, concrete,

bitumen or similar. The Antenna works best when mounted horizontal, but may still

give signal improvements if mounted on an angled or vertical surface.

The wiring of the antenna requires that a 6mm hole be drilled through the mounting

surface, check on the other side of the surface to see if it's suitable.

The antenna cable is 3.5 meters long, ensure there is a suitable place to secure the

OdaLog within this distance from the antenna location. If extra length is required, a

5metre cable extension kit can be used (PN: 11-2003, sold separately)

3. Marking and Drilling:

Trace around the outline of the antenna (easiest if upside down), and mark the

approximate location of where the hole will be (easiest to mark points on the traced

outline, and sketch lines that will intersect where the hole location will be).

Taking note of the drill marking, drill 6mm hole through the mounting surface.

4. Test mount:

Locate the joining connectors in the 3.5 metre antenna cable, and disconnect. Slide the

short cable from the antenna side of through the drilled hole and check mounting

location is ok, and leave the antenna in this location during the next step.

If appearance is important, you may wish to use some wide packaging tape to

mask near the marked outline. Later in process, when epoxy starts to set, use a

disposable blade to separate the epoxy, and remove the masking (with excess

epoxy attached).

10-2003, OdaLog Surface-Mount Antenna Installation Guide

OPTIONAL MASKING

Revision: 1 ,

31/05/2010