4ms Company Dual Looping Delay Manuel de l'utilisateur - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 4ms Company Dual Looping Delay. 4ms Company Dual Looping Delay 20 pages.
Également pour 4ms Company Dual Looping Delay : Notes de mise à jour (10 pages)
Imprimer la page
Hardware Test Mode
The Hardware Test Mode is a way to verify your hardware is working correctly. This procedure is run
on every unit at the factory. If you built the Looping Delay as a DIY Kit, or if you suspect damage
occurred to your unit, you can run this procedure to verify the module is working properly.
The full procedure is described in the DIY Looping Delay Kit Build Guide found at
https://4mscompany.com/
Factory Reset
A factory reset is not necessary unless you have changed System Settings or recently upgraded
firmware versions.
To perform a factory reset, hold down Reverse and Ping while powering up. After you release the
buttons, the red light will flash to indicate the firmware version. The Ping light will then flash
repeatedly. Hold down the Ping button for five seconds until it turns on solid. Release Ping.
The Looping Delay has now been reset to its factory default settings. Power off.
Technical Specifications
•
16 HP Eurorack format module
•
0.98" (25mm) maximum depth with power cable
Power consumption:
• +12V rail: 125mA max
• -12V rail: 45mA max
• +5V rail: not used
Audio Inputs
• 20Hz to 20kHz
• 20V peak-to-peak maximum before clipping (when AC coupled)
Audio Outputs
• 0Hz (DC) to 20kHz
• +10V to -10V maximum output
Clock Out:
• 0V to 8V
• +/- 2.4µs maximum jitter (0.001% at 120 BPM)
• Rise/Fall time (10% to 90%): 350µs
Loop Clk Out:
• 0V to 8V
• Rise/Fall time (10% to 90%): 350µs
Sampling
• 24-bit sampling at 48kHz, 32-bit floating-point processing, 16-bit storage in RAM
• 64Mbit SDRAM chip
• Mono mode: Maximum of 87.38 seconds
• Stereo mode: Maximum of 43.69 seconds
Page
19
of
20