Aussie Tonneaus ATR01132 Instructions de montage - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Aussie Tonneaus ATR01132. Aussie Tonneaus ATR01132 4 pages. Hilux single cab 1989 - 2005 continuous rope tonneau cover
Imprimer la page
1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders
with the holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above
and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.
This is where you will drill a hole to the depth of about 1-2mm (do not go any further)
2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you
Make sure you do not over tighten the grub screws
drilled.
bar in the middle to give it some extra height to assist with water runoff.
. Refit the bar. You may kink the