ADEMCO Accord Instructions pour l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} ADEMCO Accord. ADEMCO Accord 10 pages.
Imprimer la page
- 1. Table of Contents
- 2. Full Set [1]
- 3. Part Set [2]
- 4. Night Set [3]
- 5. Unsetting
- 6. Unsetting after or During an Alarm
- 7. Testing the System [5]
- 8. Reprogramming Codes [8]
- 9. Isolating Zones [6]
- 10. Chime Facility [9]
- 11. Viewing the Alarm Log [0]
- 12. Indicators and What They Mean
- 13. System Settings
- 14. System Limitations
displayed first, indicated by the zone LED and
a beep.
INDICATIONS AND WHAT THEY
INDICATIONS AND WHAT THEY
MEAN
MEAN
POWER – There is one power LED at the
control unit and one on each keypad. If the
Power LEDs are on then there are no
problems with the a.c. mains supply, if the
Power LEDs are off this indicates an a.c.
mains failure.
An a.c. mains failure may be accompanied by
an audible warning (if programmed). This can
be silenced by entering a valid code.
If the Power LEDs are flashing contact your
Alarm Company. Do not press any keys.
TAMPER – If the Tampers LED on the
keypad(s) is on one of the system devices has
been tampered with. Contact your Alarm
Company for advise.
DAY LEDs
'On' – This indicates that the sytem is unset.
'Flashing' – This indicates that the system is
setting.
The LED will extinguish when the
system has successfully set.
ZONE LEDs
'On' – This indicates that the zone has
caused an alarm or the zone is not clear
during the setting procedure.
If you are in the Test mode it indicates that the
zone has been successfully tested.
'Flashing' – This means that the zone has
been Isolated.
'Off' – This is the normal condition for zone
LEDs.
6