ADEMCO Ademco VISTA-20P Manuel de démarrage rapide - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} ADEMCO Ademco VISTA-20P. ADEMCO Ademco VISTA-20P 6 pages. Programming auto arming and disarming schedules
Également pour ADEMCO Ademco VISTA-20P : Manuel d'installation rapide (2 pages), Manuel de programmation (17 pages), Manuel de l'utilisateur (20 pages), Manuel de programmation (17 pages), Manuel d'installation rapide (2 pages), Manuel d'installation rapide (2 pages), Manuel de programmation (2 pages), Manuel rapide (2 pages)

Step 10: Dialer Delay (*50)

 Enter 0 for no dialer delay

Step 11: Changing the Master Code and User Codes

Changing the master code

 Enter the Master code + 8 + 02 + New Code + the New Code again. The

keypad will beep 1 time for confirmation letting you know the code was

successfully changed.

Changing the User codes

 Enter the Master/Partition Programmer Code + [8] + User Number + New

Code NOTE: User number can be 03-49. This can be done from any

partition. The keypad will beep 1 time for confirmation letting you know the

code was successfully entered.

Press *99 to exit programming

Step 12: Time and Date

 Enter your Master Code (default 1234) and # 63 then *.

 Using the number pad, enter the hour, then minutes. Press 1 for PM. or 2

for AM. Then press the year and then * to save.

Adding Additional Keypads:

The following are ways to add keypads to your system. Keep in mind keypads

can be addressed 16 to 23 with no duplicates in the addresses. The keypad

should come defaulted at 31, but we will default the keypad to make sure

everything is correct.

Step 1: Upon Power Up of the new keypad (when the main display goes blank),

Press and hold the "1" and "3" simultaneously. Then "--oo" will flash.

Step 2: While "--oo" is flashing enter "91", then the system will beep and "--oo"

will be displayed.

Step 3: Press "1" and then the display will show "Ca 31"

Step 4: Enter "00" and then the address of the keypad. For the second keypad

this would be 17, 18 for the third keypad, etc. Enter * to save. "--00" will be

displayed and enter * again.

Your display will then show "Ad 00 17" (or the new address). The keypad will

restart on its own.

Step 5: On your programming keypad (Main Keypad 6160, 6160RF, or 6160V),

enter into the programming mode. You will need to activate address you used

(i.e. 17) in the programming section. Use the Installation and Setup Guide for

assistance on enabling your keypad address on page 2-5.