GREAT PLANES YAK-55M Yakovlev Manuel d'instruction - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES YAK-55M Yakovlev. GREAT PLANES YAK-55M Yakovlev 20 pages. Arf plane
Imprimer la page
rest on a hardwood block in the aileron. Mark the location
of the mounting holes onto the aileron. Drill a 1/16" [3.2mm]
hole on the marks, approximately 3/8" [9.5mm] deep. Do not
drill completely through the top of the aileron.
❏ ❏
6. Thread two #2 x 3/8" [9.5mm] self-tapping screws
through the control horn, into the aileron control horn block.
Remove the two screws and harden the screw holes in the
aileron with thin CA. After the CA has cured, reinstall the
control horn.
❏ ❏
7. Slide a silicone clevis retainer over the clevis. With
the aileron servo and the aileron centered, mark the aileron
pushrod where it crosses the aileron servo arm. Make a 90°
bend at the mark. Cut the pushrod 3/8" [9.5mm] past the
bend. Attach the pushrod to the aileron servo arm with a
™
nylon Faslink
.
❏ ❏
8. Use thin CA to glue the two plastic wing alignment
pins in the root rib. The pins should protrude from the rib
approximately 1/4" [6.4mm].
❏
9. Repeat steps 1-8 for the left wing panel.
ASSEMBLE THE FUSELAGE
Install the Stabilizer
❏
1. Center the wing tube in the fuselage. Slide the wing
halves onto the wing tube and secure the wing halves to the
fuselage with the aluminum thumb screws.
7