ADEMCO 5804 Instructions d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} ADEMCO 5804. ADEMCO 5804 3 pages. Wireless key transmitter

Imprimer la page

WIRELESS KEY

TRANSMITTER

Installation Instructions For Colored

Adhesive Labels And Buttons

The No. 5804 is supplied with colored buttons (Red

and Blue) and colored adhesive identification labels

(Blue, Red, Gray and Green).

specified command function and symbol printed on it,

as well as an adhesive back for easy pasting.

To paste a label on a button, slowly peel off a selected

function and paste on the button of the transmitter.

If you decide to re-program a button, the label can be

easily removed or a new label pasted over the existing

one.

Additional colored buttons are also provided (red and

blue) which can be used with or without the labels.

The buttons can only be inserted in the areas provided

for them (see Figure 2).

To insert the colored buttons, do the following:

Holding the transmitter with the buttons face

down, remove the case back by using the blade of

a small screwdriver to pry open (see Figure 1).

Carefully remove the PC board by its rubber

casing, making sure the board does not come out

of the casing. Do not to bend the exposed battery

tabs on the PC board.

Replace the desired buttons, either red or blue, in

each button's designated opening (see Figure 2).

When finished, replace the PC board, making

sure the button tabs on the board face the four

buttons, and snap case front and back together.

N7674-1 7/95

No. 5804

Each label has a

Battery Tabs Shown

Figure 1

Figure 2

REFER TO THE INSTALLATION INSTRUCTIONS

FOR THE RECEIVER/CONTROL WITH WHICH THIS

DEVICE IS USED FOR WARRANTY INFORMATION,

AND FOR DETAILS REGARDING THE LIMITATIONS

OF THE ENTIRE ALARM SYSTEM.

ALARM DEVICE MANUFACTURING COMPANY

A DIVISION OF PITTWAY CORPORATION

165 Eileen Way, Syosset, New York 11791

Blue

Red