ADEMCO 5817CB Manuel de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} ADEMCO 5817CB. ADEMCO 5817CB 2 pages. Wireless commercial / household transmitter
Également pour ADEMCO 5817CB : Instructions d'installation (4 pages), Manuel d'installation et de configuration (2 pages), Instructions d'installation (2 pages), Manuel d'installation et de configuration (2 pages)

Imprimer la page

5817CB

The 5817CB is a universal contact-monitoring transmitter that can be

used with household and commercial fire and burglary-initiating devices

such as door/window contacts, motion and glassbreak detectors,

sprinkler water flow switches, tamper switches, post indicator valves,

manual pull stations and remote duct detectors. Upon activation, it

emits an RF signal to a control panel, sending a burglary or fire alarm

to a central station.

FEATURES:

• The 5817CB has three unique input loops (zones).

• The first loop (primary loop) is supervised and typically used for

high-priority alarm reporting such as commercial fire or burglary.

• The second loop is the built-in, normally closed reed switch used

in conjunction with magnet.

• The third loop is another normally closed household burglary loop.

All three loops may be used.

• A fourth (automatically enrolled) loop contains two tamper switches

to protect the 5817CB.

MOUNTING:

For proper orientation of the unit in relation to its wall mounting plate and the loop wiring, read

entire section before installation. Before mounting the transmitter permanently, conduct Go/No

Go tests to verify adequate signal strength. When a satisfactory location is found, remove the

battery and proceed with installation.

1. Remove the transmitter cover by inserting

the flat blade of a small screwdriver into

the pry-off slot at the bottom end of the

unit (on the right side closest to the

cover's decorative ribs and twisting).

2. Disengage the supplied mounting plate

from the unit by inserting the blade of a

small screwdriver into the mounting plate

release hole (see Diagram 2) and pushing

the locking tab out (see Diagram 1). Slide

the mounting plate downward along the

case back.

Note: For this application, the alignment

guide strip along one edge of the mounting

plate serves no function and may be

broken away, if desired.

3. If concealed wiring is to be used, feed the

wires through the concealed wiring entry

hole on one corner of the plate (surface

wiring is mentioned in step 5 below).

4. Install the mounting plate, with its case-

holding posts pointing up, in the location

selected as described in the installation

instructions. Use the two flat-head screws

supplied. Note: To ensure proper

operation of the unit's back tamper (when it

is separated from the mountain plate), the

screws must be anchored to a wall stud or

other solid wood material.

5. Set the DIP switch (after the control panel

has enrolled the transmitter's input ID's) for

the desired primary loop characteristics, as

described in the table on the following

page.

Wireless

Commercial

Transmitter