ADEMCO 5808C Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ADEMCO 5808C. ADEMCO 5808C 4 pages. Wireless photoelectric smoke detector

An ADEMCO Group Company

5808/5808C

C. Smoke entry test

Hold a smoldering punk stick or cotton wick at the side of the detector and gently

blow smoke through the detector until the unit alarms.

D. Direct heat method (hair dryer of 1000-1500 watts)

Direct the heat toward either side thermistor. Be sure to hold the heat source about 12

inches from the detector to avoid damage to the plastic. The detector will reset only

after it has time to cool.

Smoke detection testing is recommended for verifying system protection capability.

A detector that fails to activate with any of these tests should first be cleaned. If the

detector still fails to activate, return for repair.

Notify the proper authorities that the system is back on line.

Testing transmitter signal

Note: Remove battery tab before installation.

This test should be performed before installation to determine a strong communication path

with the control panel and after installation is complete. Also, the owner/user should test

the unit at least weekly.

1. Activate the wireless system's TEST mode from the console.

2. Depress and hold the smoke detector's TEST switch and the detector should immediately

transmit and alarm signal to the control panel. The built-in horn will start to sound about

2.5 seconds after depressing the button.

3. The wireless system's console should emit at least three audible sounds when the alarm

transmission is received and will display the transmitting detector's ID number.

4. When the console has received the test signal, release the TEST switch. The horn will

immediately stop and a few seconds later, the detector's ID number will clear from the

console display.

5. If the console does not respond as noted, check the polarity of the batteries and be sure

they are fresh. If this is an initial installation, try moving the detector to another location

that provides proper reception. Also, be sure that the detector's ID has been "enrolled"

by the control panel (see programming). Then, repeat the test.

6. Turn off the system's TEST mode from the console (security code + off).