Maintronic Sx2 Tuning-Dongle Manuel d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Maintronic Sx2 Tuning-Dongle. Maintronic Sx2 Tuning-Dongle 5 pages. For ebike; with bosch active / bosch performace line cablekit sx2kb-perf
cause an installed SX2 Tuning-Dongle is a modification
or a manipulation of your eBike.
Once the terminals are crimped, the speedsensor plug
(1) should be reconnected to the engine and the chain
applied to the chain wheel.
Now the pedal has to be turned up slowly by hand and
the speedometer should be checked for function. If the
speed is shown on the display repeat the procedure
with a plugged Sx2 Tuning-Dongle into stereo jack so-
cket (5). Until the switch point is reached, the shown
speed jumps to the half speed.
After that, assemble the hood and the e-bike together.
The cablekit should be mounted in a way to protect
the connectors from splashing water and mechanical
damage.
On the following page is a picture of the terminal with a
connected cablekit.
good eBike dealer.
2
to Control
Unit Intuvia
light-
socket
black
red (+5V)
BOSCH Active Line
BOSCH Performance Line
FAQ
(further Help you can find at support.maintronic.de)
I have done the installation exactly like shown, but the
switchoverpoint is not perceptible?
ANSWER:
Distance and Position of the magnet affecting the
7
3
Speed-
sensor
light-
socket
red
black
8
- Ground
Sx2
switching time of the speed sensor. The shorter the
switching time, the sooner is the switchoverpoint and
conversely. Try to turn up the pedal by hand while the
engine is turned off till 50km/h and watch the speedo-
meter.
If the switchoverpoint is below 12km/h or over 28km/h
or not at all please contact your specialist dealer or the
Sx2 Support >>> [email protected]
How can I influence the switchoverpoint?
ANSWER:
If the speed sensor with the magnet is moved into the
axis direction, the switching speed increase.
Conversely the speed sensor with the magnet is moved
outside to the tire direction, the switching time is shor-
ter and the switching speed is lower.
Manual >>> support.maintronic.de.
Is the cablekit connected correctly?
ANSWER:
Poor contacts may arise fail pulses with the Sx2 Tuning-
Dongle which causing the error 102. Check the tight-
ness of the Sx2 Tuning-Dongle and its contacts.
(Picture with stereo jack socket and measurement de-
vice)
For a further diagnose a bare 3,5mm stereo jack instead
of the Sx2 Tuning-Dongle are plugged. The measure-
ments must be +5V stable between ground(peak) to
ring, the magnet may not stay over the speedsensor.
4