Game Winner GW 6 Instructions d'assemblage et manuel d'utilisation - Page 10

Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage et manuel d'utilisation pour {nom_de_la_catégorie} Game Winner GW 6. Game Winner GW 6 13 pages. Tray dehydrator

Imprimer la page
Dehydrator Troubleshooting Guide
Symptom
No Heat
No power
No Fan
No Heat
Broken wire in unit
Fan-OK
Heat-OK
Motor
No Fan
blocked
Slow drying
Trays overfilled
Fan jammed or running too
slowly
Air leaks due to warped or
improperly stacked trays
Uneven drying
Variation in food thickness
and ripeness
Trays not rotated
Too much food in drying
trays
Overheating
or
Temperature control not
insufficient heat
functioning at proper range
Noisy
Fan
/
Foreign matter in fan
Motor
Motor bearing worn
Possible Cause
stalled
or
fan
Page 9 of 12
Possible Solutions
1.
Be sure unit is plugged in.
2.
Make sure power switch is on.
3.
Check that outlet is working.
Not user repairable
Return for service
Turn off immediately.
Check for foreign objects (pieces of dried food)
jamming fan. Turn base assembly upside down
and shake vigorously. Turn unit on side and
shake particles out. If fan still doesn't operate,
return unit for service.
If liquid has been spilled into the air vents or the
fan housing, unplug immediately and return the
unit for service.
Air must flow freely around for proper drying.
Reduce quantity in trays or rearrange food.
Check for foreign objects jamming fan (see
<Heat-OK, No Fan> above).
Fan motor running slow. Return for service.
Replace warped trays. NOTE: The heat during
drying cycle on most dishwashers may warp the
drying trays.
Re-stack trays properly.
Check that food is similar thickness.
Rotate trays once or twice during dehydration
process.
Check that food on trays is not blocking air flow
through tray stack. Make sure central chimney
of tray is not obstructed.
Temperature in the lowest tray should be
approximately 140ºF (60ºC) with empty trays in
place. If temperature varies significantly, adjust
accordingly higher or lower or return for service.
Check for foreign objects jamming fan (see
<Heat-OK, No Fan> above).
Return for service.