IKEA IUD9500VX0 Instructions pour l'utilisateur - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} IKEA IUD9500VX0. IKEA IUD9500VX0 20 pages. Undercounter dishwasher plastic giant tubmodels
Également pour IKEA IUD9500VX0 : Manuel d'instructions d'installation (40 pages)
Imprimer la page
Fresh a utomatic
dishwasher
detergent
results i nbetter
cleaning. Store t ightly
closed d etergent
container inacool, d ry
place.
A. Cover latch
B. Main Wash section
C. Pre- Wash section
•
The amount of detergent to use depends on:
How much soil remains on the items - Heavily soiled loads
require more detergent.
The hardness of the water - If you use too little in hard water,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
Soft to Medium Water (0-6 grains per U.S. gallon)
[typical water softener water and some city water]
Medium to Hard Water (7-12 grains per U.S. gallon)
[well water and some city water]
•
Depending on your water hardness, fill the Main Wash section
of the dispenser as shown. Fill the Pre-Wash section to the
level shown, if needed.
NOTE: Fill amounts shown
are for standard powdered
detergent. Follow
instructions on the package
when using other dishwasher
detergent.
X
ard Water
Soft Water
Main Wash
HardWater
Soft W ater
Pre-Wash
Add Rinse Aid
Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
Rinse aid helps to reduce excess moisture on the dish
racks and interior of your dishwasher.
C
Full
Add
Check the rinse aid indicator. Add rinse aid when indicator
drops to "Add" level.
To add rinse aid, turn the dispenser cap
to "Refill" and lift off. Pour rinse aid into
the opening until the indicator level is at
"Full." Replace the dispenser cap and
turn to "Lock." Make sure cap is fully
locked.
Lock
Refill/_
turn to lock
NOTE: For most water conditions, the
factory setting of 2 will give good
results. If you have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting
a flat-blade screwdriver into the center
of the arrow and turning.
STEP3
Select
a Cycle (cycles
vary by model)
See "Cycle and Option Descriptions"
charts in the following
section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 31/2hours to complete.
Cycles
Heavy
Normal
Rinse
@ Only
or
Heavy
CYCLES
Light/
China
Rinse_
Only
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired.
Options
Sani-
Heated
4 Hour
_}
tize
_
Dry
_
Delay
or
OPTIONS
High
Temp
STEP 4
Start or Resume
a Cycle
Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
Push door firmly closed. The door latches
automatically. Select the wash cycle and options
desired OR press START/RESUME to repeat the
RESUME
same cycle and options as in the previous wash
cycle.
You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.