Garmin GMR Fantom 56 Manuel d'instructions d'installation - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GMR Fantom 56. Garmin GMR Fantom 56 19 pages.
Également pour Garmin GMR Fantom 56 : Manuel du propriétaire (12 pages)
Imprimer la page
Specifying the Antenna Size
Before you can use the radar on your system, you must specify the antenna size.
1 Turn on the radar and all devices connected to the Garmin Marine Network.
An antenna-selection prompt appears on the connected chartplotters.
NOTE: If the entire system is being turned on for the first time, the antenna-selection screen is part of the
initial setup process.
2 Select the installed antenna size for each open-array radar installed on the boat.
TIP: If you need to specify a different antenna size, while viewing the radar screen for the radar you want to
change, select Menu > Radar Setup > Installation > Antenna Configuration > Antenna Size, and select the
antenna size.
Front-of-Boat Offset
The front-of-boat offset compensates for the physical location of the radar scanner on a boat, if the radar
scanner does not align with the bow-stern axis.
Measuring the Potential Front-of-Boat Offset
The front-of-boat offset compensates for the physical location of the radar scanner on a boat, if the radar
scanner does not align with the bow-stern axis.
1 Using a magnetic compass, take an optical bearing of a stationary target located within viewable range.
2 Measure the target bearing on the radar.
3 If the bearing deviation is more than +/- 1°, set the front-of-boat offset.
Setting the Front-of-Boat Offset
Before you can set the front-of-boat offset, you must measure the potential front-of-boat offset.
The front-of-boat offset setting configured for use in one radar mode is applied to every other radar mode and
to the Radar overlay.
1 From a Radar screen or the Radar overlay, select Menu > Radar Setup > Installation > Front of Boat.
2 Select Up or Down to adjust the offset.
Setting a Custom Park Position
By default, the antenna is stopped perpendicular to the pedestal when it is not spinning. You can adjust this
position.
1 From the radar screen, select Menu > Radar Setup > Installation > Antenna Configuration > Park Position.
2 Use the slider bar to adjust the position of the antenna when stopped, and select Back.
13