AEG 35944G Manuel d'utilisation et d'installation - Page 21

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} AEG 35944G. AEG 35944G 26 pages. Gas hobs
Également pour AEG 35944G : Instructions d'utilisation et d'installation (26 pages), Instructions d'utilisation et d'installation (26 pages), Instructions d'utilisation et d'installation (26 pages), Instructions d'utilisation et d'installation (27 pages)

Permanent Connection

In the case of a permanent connection, it is necessary that you install

a double pole switch between the hob and the electricity supply

(mains), with a minimum gap of 3 mm. between the switch contacts

and of a type suitable for the required load in compliance with the

current electric regulations.

The switch must not break the yellow and green earth cable at any

point.

Ensure that the hob supply cord does not come into contact with

surfaces with temperatures higher than 50 deg. C.

Replacement of the cable

The connection of the voltage cable to the appliance's terminal block

is of type "Y". This means that its replacement requires the specific

equipment of a technician.

In this case, only cable type H05RR-F must be used. The cable section

must be suitable to the voltage and the working temperature.

The yellow/green earth wire must be approximately 2 cm. longer than

the phase wires.

1. TAPS IGNITOR SWITCHES

2. IGNITOR UNIT

Electrical connections

220

240