Brother PS-9000 Manuel de l'utilisateur - Page 33
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Brother PS-9000. Brother PS-9000 47 pages. User manual
Également pour Brother PS-9000 : Brochure & Specs (6 pages), Manuel de l'utilisateur (43 pages)
Imprimer la page
Symptom
The print job is
not printed.
Dial-up starts
when printing
is performed.
An error
occurs during
printing.
LPR printing is
not available
with PS-9000.
The tape width
cannot be
detected by
P-touch Editor 4
or Quick Editor.
Can PS-9000
be initialized
(reset to its
factory default
settings)?
32
Cause
If a DHCP/BOOTP server or
an RARP server resides on the
network, the IP address is
automatically issued by the
server. In this case, the IP
address that was manually set
for PS-9000 may have been
overwritten by the server.
If PS-9000 and the computer
are not in the same segment, a
subnet mask and gateway
address must to be set for
PS-9000.
Depending on the operating
system being used, the
automatic dial-up setting may
have been specified.
If the unit stopped operating
because of a tape width error
or no more tape in the cassette
during another user's print job,
printing is not possible until
the error is cancelled.
With some of the P-touch
machines, LPR printing is not
available.
If PT-9500PC is connected to
PS-9000, the tape width
detection function of P-touch
Editor 4 and Quick Editor does
not operate. (There is no tape
width detection function with
PT-9200DX.)
Remedy
Create a local environment where the server does
not exist and issue the IP address to PS-9000. At the
same time, make sure that "Obtain an IP address
automatically" in the TCP/IP setting is not marked.
Use the Brother PS-9000 Utility to check whether
the subnet mask and gateway address are correct.
Check the printer port name of PS-9000. The port
name is indicated by "(PTLAN xxxxxx: P-touch TCP
Port)" after the assigned port name.
When using PS-9000, cancel the setting for
automatic dial-up or, if the automatic dial-up setting
cannot be cancelled, click [Cancel] in the dialup
dialog box to begin printing.
After the other user's print job is finished, try printing
again. Otherwise, use the Web browser to restart
PS-9000, and then try printing again.
With the PT-9200DX, install the printing software
for PS-9000 onto each client, and use it instead of
using LPR printing.
Manually specify the tape width.
PS-9000 can be initialized (reset to its factory default
settings) by using the Brother PS-9000 Utility.
Select PS-9000 in the PS-9000 setting dialog box of
the Brother PS-9000 Utility, and then click
[Initialize]. Otherwise, PS-9000 can be initialized by
pressing the push button. For further information on
how to initialize PS-9000 by pressing the push
button, refer to "Parts and Functions" in chapter 1,
"About PS-9000".