AEG OKO-LAVAMAT BELLA2100 Livret d'instructions - Page 40
Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} AEG OKO-LAVAMAT BELLA2100. AEG OKO-LAVAMAT BELLA2100 45 pages. Aeg the environmentally friendly washing machine
Imprimer la pageInstallation
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by
carpets, rugs etc.
• Before placing it on small tiles, apply a rubber coating.
• Never try to correct any unevenness in the floor by putting pieces of
wood, cardboard or similar materials under the machine.
• If it is impossible to avoid positioning the machine next to a gas
cooker or coal-burning stove, an insulating panel (85x57 cm) covered
with aluminium foil on the side facing the cooker or stove, must be
inserted between the two appliances;
• The machine must not be installed in rooms where the temperature
can drop below 0.
• The water inlet hose and the drain hose must not be kinked.
• Please ensure that when the appliance is installed, it is easily accessi-
ble for the engineer in the event of a breakdown.
Levelling
Carefully level by screwing the adjustable
feet in or out. Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the
floor.
Water inlet
Connect the water inlet hose to a separate
tap with a 3/4" thread.
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window "A". Should this occur, turn the
water tap off and refer to your Service Cen-
tre to replace the hose.
The other end of the inlet hose which con-
nects to the machine can be turned in any
direction. Simply loosen the fitting, rotate
the hose and retighten the fitting, making
sure there are no water leaks.
40