Brother MFC-J4610DW Manuel - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Brother MFC-J4610DW. Brother MFC-J4610DW 22 pages. Quick setup guide - spanish
Également pour Brother MFC-J4610DW : Manuel d'installation rapide (47 pages), Manuel (36 pages), Manuel de sécurité des produits (17 pages), Manuel (13 pages), Manuel (13 pages), Manuel d'installation rapide (45 pages), Manuel de sécurité des produits (20 pages), Manuel de démarrage rapide (29 pages), Manuel de sécurité des produits (25 pages), Commencer ici Manuel (47 pages), (Espagnol) Manuel Guia De Web Connect (38 pages), (espagnol) Manuel (24 pages), (anglais) Product Safety Guide Manual (16 pages), (espagnol) Manuel (12 pages), (espagnol) Manuel (11 pages), (anglais) Quick Configuration Guide (47 pages)

Glossary

If you set Group Owner to On, your Brother machine serves as an access point when you configure a Wi-Fi

Direct network. The G/O assigns an SSID name, password and IP address for the Wi-Fi Direct network. The

default setting is Off.

Device Name

You can check the device name of the Brother machine in the Wi-Fi Direct network environment. The device

name will be shown as MFC-xxxx or DCP-xxxx (where xxxx is your model name.).

SSID

This field displays the current Wi-Fi Direct network SSID name. The display shows up to 32 characters of the

SSID name.

IP Address

This field displays the current IP address of the machine, as assigned by the G/O.

Status

This field displays the current Wi-Fi Direct network status. When your machine is a G/O, it displays the

message G/O Active(**) (where ** is the number of devices). When your machine is a client, the machine

displays the message Client Active. If you see Off, your machine's Wi-Fi Direct interface is disabled.

Signal

This field displays the current Wi-Fi Direct network signal strength.

Channel

This field displays the current Wi-Fi Direct network channel.

Speed

This field displays the current Wi-Fi Direct network speed.

If you want to use the Wi-Fi Direct network connection, set I/F Enable to On.