Indesit PI 640 A R Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Indesit PI 640 A R. Indesit PI 640 A R 11 pages.
Également pour Indesit PI 640 A R : Manuel d'utilisation (15 pages)

Imprimer la page

Fastening hooks are provided, allowing you to

fasten the hob to tops that are between 20 and 40

mm thick. To ensure the hob is securely fastened to

the top, we recommend you use all the hooks

provided.

Hook fastening diagram

Hooking position

for top H=20 mm

Hooking position

for top H=40 mm

Use the hooks contained in the accessory pack

Where the hob is not installed over a built-in oven, a

wooden panel must be installed as insulation. This

must be placed at a minimum distance of 20 mm

from the lower part of the hob.

Ventilation

To ensure adequate ventilation, the back panel of the

cabinet must be removed. It is advisable to install the

oven so that it rests on two strips of wood, or on a

completely flat surface with an opening of at least 45 x

560 mm (see diagrams).

555 mm

Hooking position

for top H=30 mm

Front

Back

Where a hob is installed above an oven without a

forced ventilation cooling system, adequate ventilation

must be provided inside the cabinet by means of air

holes through which air can pass (see figure).

! The PI 640 AST hob can only be installed above

built-in ovens with a cooling ventilation system.

Electrical connection

Hobs equipped with a three-pole power supply cable

are designed to operate with alternating current at the

voltage and frequency indicated on the data plate

(this is located on the lower part of the appliance). The

earth wire in the cable has a green and yellow cover.

If the appliance is to be installed above a built-in

electric oven, the electrical connection of the hob and

the oven must be carried out separately, both for

electrical safety purposes and to make extracting the

oven easier.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate.

The appliance must be directly connected to the mains

using an omnipolar circuit-breaker with a minimum

contact opening of 3 mm installed between the

appliance and the mains. The circuit-breaker must be

suitable for the charge indicated and must comply with

current electrical regulations (the earthing wire must not

be interrupted by the circuit-breaker). The supply cable

must not come into contact with surfaces with

temperatures higher than 50°C.

The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.