2N Lift8 Manuel succinct - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel succinct pour {nom_de_la_catégorie} 2N Lift8. 2N Lift8 6 pages. Io module
Également pour 2N Lift8 : Manuel succinct (8 pages), Manuel succinct (12 pages), Manuel succinct (13 pages), Manuel succinct (14 pages), Manuel succinct (12 pages), Manuel succinct (17 pages)

This audio unit is designed for installation on the lift shaft bottom or lift cabin roof, or

wherever it is necessary to communicate (during lift maintenance, e.g.). Theaudio unit is

enclosed in a robust yellow cover. It is not intended for outdoor use but perfectly tolerates

the conditions in lift shafts: is resistant against fall of small objects, dripping oil, etc. The

ALARM button activates the control centre connection, the TRIPHONY bottom enables

conference connection with the other audio units of one and the same lift. The audio

unit contains a built-in microphone and a speaker. A handset can be connected for better

acoustic properties. Thanks to its size and robustness, the audio unit has a very good,

strong sound.

Connector description

The audio unit has one connector for bus connection. The second RJ–11 connector is used

for handset connection. Both the connectors are under the side doors.

Bus connection

Loosen the screws to the right and open the connector cover. There is just one connector

under the cover: a bus connector. Pull out the terminal from the connector, connect the

wires and replace the terminal. Make sure that the polarity is maintained.

Warning

Connection to different, e.g. higher-voltage, cables leads to damage or



destruction of the audio unit.

Maintain polarity while connecting the audio unit to avoid audio unit error.



Caution

The audio unit is powered via a 2-wire bus. Disconnection of these wires



results in the audio unit switch-off.

Audio unit location configuration

Audio unit location means configuration of jumpers (see the cover print). You do not have

to change the jumper configuration if you are installing the audio unit at the shaft bottom.

Otherwise, proceed as follows:

Procedure:

1. Loosen the screws on the jumper-protecting door and open the door.

2. Configure the required change according to the printed figure below the door

(this audio unit cannot be configured as common for multiple).