AEG ARCTIS Mode d'emploi et manuel d'installation - Page 25

Parcourez en ligne ou téléchargez le pdf Mode d'emploi et manuel d'installation pour {nom_de_la_catégorie} AEG ARCTIS. AEG ARCTIS 28 pages. Built-in fridge-freezers
Également pour AEG ARCTIS : Manuel d'utilisation (32 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (28 pages), Instructions d'utilisation (16 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (26 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (27 pages), Manuel d'utilisation (34 pages), Manuel de l'utilisateur (24 pages), Manuel d'instructions d'installation (11 pages), Manuel d'utilisation (29 pages), Manuel d'utilisation (23 pages), Manuel d'instructions d'installation (25 pages), Manuel d'instructions d'installation (24 pages)

Imprimer la page
AEG ARCTIS Mode d'emploi et manuel d'installation
Symptom
Heavy build up of frost,
possibly also on the door
seal.
The compressor does not
start immediately after
changing the temperature
setting or pushing the fast
freeze button.
Noise
If after the above checks there is still a fault, call your local AEG Service
Force Centre.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
Please note that proof of purchase is required for in-guarantee service
calls.

Noises during Operation

The following noises are characteristic of refrigeration appliances:
• Clicks
Whenever the compressor switches on or off, a click can be heard.
• Humming
As soon as the compressor is in operation, you can hear it humming.
• Bubbling/Splashing
When refrigerant flows into thin tubes, you can hear bubbling or
splashing noises. Even after the compressor has been switched off,
this noise can be heard for a short time.
818 2113-00/4
Possible Cause
Door seal is not air tight
(possibly after changing
over the hinges).
This is normal, no error has
occurred.
Appliance is not level.
Appliance is in contact
with wall or other objects.
A part at the back of the
appliance, e.g. a tube, is in
contact with another
appliance part or the wall.
Solution
Carefully warm the leak-
ing sections of the door
seal with a hair dryer (not
hotter than approx. 50 °C).
At the same time shape the
warmed door seal by hand
such that it sits correctly.
The compressor starts after
a period of time.
Readjust the front levelling
feet.
Push appliance away a
short distance.
Bend this part away care-
fully if necessary.
25