AEG SANTO 70398-28 DT Manuel d'utilisation - Page 28

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} AEG SANTO 70398-28 DT. AEG SANTO 70398-28 DT 40 pages.

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-

ply voltage and current values correspond with those of the mains at the

installation location.

e.g.:

(i.e. 220 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance on the left.

A correctly installed, earthed socket is required for the electrical supply. The

supply must have a fuse rating of at least 10 Amps.

If the socket is not accessible once the appliance is built in, the electrical

installation must include suitable means of isolating the appliance from the

mains (e.g. fuse, cut-out, current trip or similar with a minimum contact

separation of 3 mm).

Attention: The mains connection cable may only be replaced by a skilled

electrician. Please contact your dealer or our customer service department

for repairs.

Prior to Initial Start–Up

• Please clean the appliance interior and all accessories prior to initial start-

up (see section: "Cleaning and Care").

• Insert the plug of the connection lead into the plug socket with protecti-

ve earth contact. When the refrigerator compartment door is opened, the

internal lighting is switched on. The temperature selector knob is located

on the RH side of the refrigerator compartment.

Setting „0" means: Off.

Setting „1" means: Hightest temperature, (warmest setting).

Setting „6" (end-stop) means: Lowest temperature, (coldest setting).

However, the exact setting should be chosen keeping in the mind that the

temperature inside the refrigerator depends on:

-the quantity of food stored

-how often the door is opened

The temperatures in the refrigerator compartment and freezer co partment

cannot be independently regulated.

If you want the freeze fresh food rapidly, select setting „6", ensuring that the

temperature in the refrigerator compartment does not drop blow 0°C. You

should also promptly reset the temperature regulator to setting „3" or „4".

220 ... 240 V

220 ... 240 V~

50 Hz

50 Hz or