AEG TR8TRIER Manuel de l'utilisateur - Page 24

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG TR8TRIER. AEG TR8TRIER 32 pages.

Imprimer la page
Error code
Internal fail. No communication between
electronic elements of the appliance.
E90 or E91
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
11.2 Troubleshooting
Problem
The tumble dryer is not connected to the
mains supply.
The door is open.
The tumble dryer
does not operate.
The Aan/Uit button was not pushed.
The Start/Pauze button was not touched.
The appliance is in standby mode.
Incorrect program selection.
The filter is clogged.
Droogtegraad option was set to
droog .
The load was too large.
Unsatisfactory drying
result.
The airflow slots are clogged.
There is some dirt on the humidity sensor in
the drum.
The dryness level was not set to the desired
level.
The condenser is clogged.
The filter is not locked into position.
The loading door
Laundry is trapped between the door and
does not close
the seal.
24
ENGLISH
Possible cause
Possible cause
3)
The programme was not finished properly
or the appliance stoped too early. Switch
the appliance off and on again.
If the error code appears again, contact the
Authorised Service Centre.
When the appliance is showing EH0, please
wait until main supply is stable than press
start. If the appliance pause the cycle with‐
out any indication then press the cycle start.
If the warning will occur check the power
cord / socket integrity or main supply.
Connect it to the mains socket. Check the
fuse in the fuse box (domestic installation).
Close the door.
Push the Aan/Uit button.
Touch the Start/Pauze button.
Push the Aan/Uit button.
Select a suitable program.
Clean the filter.
Change Droogtegraad option to a higher
strijk‐
level.
Do not exceed the maximum load size.
Clean the airflow slots at the bottom of the
appliance.
Clean the front surface of the drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close the door.
Remedy
Remedy
1)
2)
4)
2)