AVS RS4F Manuel d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AVS RS4F. AVS RS4F 9 pages. Parking sensors

STEP 4 – OPERATION / TESTING THE FRONT SENSORS

When the brake pedal is pressed the front sensors remain active for 12 secs or 20 seconds depending on the model

(AVS RS8B / AVS RS8D = 12 secs, AVS RS4F = 20 secs). Objects in range of the sensors will be indicated by the

buzzer/display. See the table below:

IMPORTANT NOTES

Ø Parking sensors are an aid to vehicle reversing and parking however they are not a replacement for rear vision

mirrors. Always use the vehicle's mirror and visually check for obstacles before moving the vehicle.

Ø Reversing speed must never exceed 6km/h.

Ø Immediately stop the vehicle when the buzzer sounds continuously as this indicates an obstacle is within 40cm

of the vehicle.

Ø Disconnect the vehicle battery before making any electrical connections to the vehicle.

Ø The system must only be installed by a professional installer with suitable qualifications, experience and tools.

Ø Clean sensors regularly as dust or snow can reduce accuracy.

Ø If the vehicle is washed with high pressure water jets the sensors can temporarily lose sensitivity. This will return

to normal once the water has completely evaporated.

Ø Do not position the control unit, sensors or cables near heat sources such as the engine or exhaust.

Ø Disconnect power before disconnecting sensors. The system must be restarted after any sensor has been

disconnected/connected. Cycle power before re-testing.