Dell 2000 Manuel de configuration - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Dell 2000. Dell 2000 18 pages. Setup guide
Également pour Dell 2000 : Informations sur l'installation et les caractéristiques (8 pages)
Imprimer la page
NOTE: If the Add New Hardware Wizard screen appears, click Cancel.
2.
Go to the next section, "Installing Software for a Printer."
NOTE: Dell installs the software for some new printers. To determine if your printer's
software is already installed, click the Start button, point to Settings, and then click
Printers. If your printer is listed in the Printers window, the printer is ready to use; no
software installation is required.
Most new printers provide installation CDs that run automatically when inserted in the
CD-ROM or DVD-ROM drive. Install the software for these printers by inserting the
CD and following the prompts on your screen using the instructions that came with
the printer. It is not necessary to use the Printer Wizard to install these types of
printers.
If your printer's installation CD does not automatically run, click the Start button, click
Run, and type
, where is the letter of your CD-ROM or DVD-ROM
drive (typically drive D). Then click OK, and follow the prompts on your screen.
NOTE: If you are adding an older printer and the printer does not respond after you
install the software, make sure that the system's parallel port is set to operate in
bidirectional mode in the system setup program. See Appendix B, "System Setup
Program," in your system's Reference and Troubleshooting Guide for instructions.
USB connector on
computer
USB printer
cable
Using Hardware Devices
USB connector on
printer
3-3