Dell Force10 S25P Manuel - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dell Force10 S25P. Dell Force10 S25P 48 pages. Installing the s25p system
Également pour Dell Force10 S25P : Manuel de démarrage rapide (27 pages)

Imprimer la page

1. Accessing the Console Port

To install a module, follow the steps below:

Step

Task

If the switch is on, save the running configuration, if desired (and different from the startup configuration) with

the command write memory. Then power down the system by unplugging it from its power source.

Removing a module from a running system will lock up the switch, requiring a power

Caution:

cycle.

Use a #2 Phillips screwdriver to remove either a module faceplate or an existing module. Note that these slots,

when used for 10G Ethernet ports, are assigned port numbers from left to right as you face the front of the

switch. So, for clarity in programming ports, you might favor using the left-most slot for the first 10G module.

Grasping the module faceplate, remove the module from its packaging and slide it into the slot until the module

faceplate is flush with the switch.

Figure 5 Inserting Rear Module

Secure the captive screws on either side of the module.

The optical XFP 10-Gigabit module (catalog name S50-01-10GE-2P) requires additional XFP transceiver

inserts, which are not included in the module kit (see

that come with the transceiver). The CX4 module (catalog name S50-01-10GE-2C) ports do not require inserts.

Caution:

You can connect a CX4 cable to an XFP port through a CX4 XFP converter (catalog

number GP- XFP-1CX4) in the slot. However, an XFP port does not support the use of the

cx4-cable-length

If you are installing a CX4 module, and you are connecting the ports with a cable substantially shorter or longer

than 5m, use the cx4-cable-length command to set the signal strength. Use cx4-cable-length long for a

longer cable, cx4-cable-length short for a shorter cable. For details, see the Command Reference for your

software.

Note: Take care not to connect CX4 ports to 12G stack ports in the switch. The receptacles and cables

are the same, but they are incompatible. CX4 ports are labeled as such; stack ports are not labeled.

You can order several cable lengths of each type; they are not part of the module kit. For details, see

Using CX4 Cables (CX4 Cable Matrix) in the S-Series tech tips on iSupport:

https://www.force10networks.com/CSPortal20/KnowledgeBase/ToolTipsSSeries.aspx

For details on enabling ports, see the Configuration Guide for your software.

command, discussed next.

Installing XFPs on page

32)

the installation instructions

Installing the S25P