Dell PowerEdge 2400 Manuel d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 2400. Dell PowerEdge 2400 8 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 2400 : Manuel d'installation (20 pages), Manuel d'installation (8 pages), Instructions pour l'installation du rack (32 pages), Mise à jour (2 pages), Manuel d'activation (8 pages), Manuel de mise à jour (2 pages), Manuel (15 pages)

Imprimer la page
Dell PowerEdge 2400 Manuel d'installation
1-2
Dell PowerEdge 2400 Systems — Installing Redundant Power Supplies
4.
Slide the top cover about 2 centimeters (cm) (about half an inch) toward the front
of the computer and lift the cover away.
5.
Disconnect the power cable harness from the POWER connector on the small
computer system interface (SCSI) backplane board, the POWER1 connector on
the system board, and the diskette drive and other drives in the external drive
bays.
When you disconnect a cable connector from the SCSI backplane board and the
system board, press the plastic latch on one side of the connector to release it.
6.
Remove the two screws on either side of the power supply (see Figure 1-2).
Screws (2)
Top cover