Dell PowerEdge 2650 Manuel d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 2650. Dell PowerEdge 2650 20 pages. Activating the integrated raid controller
Également pour Dell PowerEdge 2650 : Manuel d'installation (26 pages), Manuel d'installation (32 pages), Information Update (14 pages), Manuel d'installation (40 pages), Manuel de remplacement (28 pages), Manuel d'instructions (8 pages), Manuel (42 pages), Manuel (15 pages), Manuel (42 pages)

Center-Mount Installation

The two-post rack kit is shipped with the brackets configured for center-mount installation.

To complete the installation, perform the following steps:

Locate the right slide assembly and push the back bracket toward the back of the slide

assembly (see Figure 1-4).

Position the right slide assembly in the two-post rack at the location you marked, push

the back bracket forward against the vertical two-post rack, secure the front center-

mounting bracket with two 12-24 x 0.5-inch pan-head Phillips screws, and secure the

back center-mounting bracket to the rack with three 12-24 x 0.5-inch pan-head

Phillips screws (see Figure 1-4).

Repeat steps 1 and 2 to install the left slide assembly in the rack.

Install the stiffening bracket into the appropriate holes at the back of the slide

assemblies and secure the bracket with a 12-24 0.5-inch pan-head Phillips screw on

each slide assembly (see Figure 1-4).

If the vertical rack is 3 inches wide, use the holes at the back end of the slide

assemblies (shown in Figure 1-4). If the vertical rack is 6 inches wide, use the holes

located 3 inches in front of the holes at the back end of the slide assemblies.

2 - Po st Ra ck I n stallation

1-7