Dell PowerVault 201S Manuel d'instructions de remplacement - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de remplacement pour {nom_de_la_catégorie} Dell PowerVault 201S. Dell PowerVault 201S 14 pages. Dell powervault 20xs storage systems enclosure services
expander module installation
Également pour Dell PowerVault 201S : Manuel d'installation du rack (26 pages), Manuel (9 pages), Mise à jour (4 pages), Configuration (2 pages), Manuel d'installation (48 pages)
Install the Hard-Disk Drives
NOTICE: Install the hard-disk drives in the same drive bays from
which they were removed.
NOTICE: Handle the hard-disk drives with care. The carriers provide
some protection, but the hard-disk drives can be damaged by rough
handling. When installing hard-disk drives, use gentle pressure to
slide them in the drive bays. Insert them slowly; never use force.
To install the hard-disk drives, perform the following steps:
1. Carefully slide the hard-disk drive into the bay (see Figure 13). When the
hard-disk drive is almost all the way into the bay, the carrier handle flips up.
Figure 13. Installing a SCSI Hard-Disk Drive (System Shown with a
Swing-out Lock Bar)
2. Close the handle to draw the drive carrier into the bay and lock the drive in
place.
3. Repeat steps 1 and 2 to install the remaining hard-disk drives.
4. For a storage system with a silver swing-out lock bar, raise the lock bar to
the lock position. The lock bar slips down into a detent. This holds the lock
bar in the lock position.
If the storage system is in a stand-alone configuration, swing the lock bar
to the left into the lock position. The lock bar slips to the right into a detent.
This holds the lock bar in the lock position.
For a storage system with a black, removable lock bar, place the left end of
the lock bar into its hole in the left side of the front panel. Then, align the
lock bar with the locking mechanism by the keylock (see Figure 14).
Dell PowerVault 2xxS Storage Systems SCSI Backplane Board Replacement Instructions
13