3 Day Blinds Angled Slat Pour commencer - Page 7

Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} 3 Day Blinds Angled Slat. 3 Day Blinds Angled Slat 8 pages.

BLIND REMOVAL
OPTIONAL HARDWARE
INSTALLATION
HOLD DOWN BRACKETS
Hold down brackets are used primarily on blinds mounted to
doors or in motor homes. If hold down brackets were ordered
at the time of purchase, the bottom rail of the blind will be
pre-drilled to accommodate the brackets. If you require hold
down brackets and no hole appears, simply drill a small hole
in the center of the bottom rail using a
• With the blind lowered to it's full length, place the pin of
each hold down bracket into the hole in each end of the
bottom rail.
• Mark the mounting surface, either to the side or back of the
window frame, through the holes in the hold down bracket.
Make sure the hold down brackets are level and aligned with
each other.
• Raise the blind and screw the hold down brackets into the
mounting surface using the screws provided.
• Mount the hold down bracket to the side or back of the
window frame so that the pin lines up with the front hole in
the bottom rail end cap with the blind fully lowered.
7
| 2 & 2
/
" Wood & Faux Wood & Angled Slat Blinds
1
2
• Using a flathead
screwdriver, open the
latches of the end
brackets.
• Holding onto both ends
of the headrail, gently
pull the blind forward
and out of the brackets,
making sure to unhook
the headrail from the
center support bracket(s),
if applicable.
/
" drill bit.
1
16
• Lower the blind and
flex the hold down
bracket outward so
that the pin can be
inserted into the hole
in the bottom rail.