Dell PowerEdge XL 5133-4 Manuel de démarrage - Page 24

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Dell PowerEdge XL 5133-4. Dell PowerEdge XL 5133-4 38 pages. Dell poweredge m i/o aggregator getting started guide

Imprimer la page

1. Internal Ports

For example:

FTOS(conf)# interface ManagementEthernet 1/0

FTOS(conf-if-ma-1/0)# ip address 128.0.0.1/24

FTOS(conf-if-ma-1/0)# no shutdown

8 (CMC-supported) To reconfigure the default route used by the out-of-

band interface to access the Aggregator from a remote network, enter the

management route subnet/mask managementethernet command, where

subnet/mask is an IP address in dotted decimal format (A.B.C.D) and a

subnet mask that defines the out-of-band management network.

FTOS(conf)# management route 10.0.0.0/24

9 (CLI only) By default, the IP address of the default VLAN used to access

the switch from an in-band routing interface is assigned by a DHCP server.

You can reconfigure the default setting by specifying an IP address with the

ip address ip-address/mask command:

FTOS(conf)# interface vlan 1

FTOS(conf-if-vl-1)# ip address 10.1.1.4/24

10 (CLI only) To reconfigure the default route used by the in-band

management interface (default VLAN) used to access the Aggregator from

a remote network, enter the ip route subnet/mask vlan 1 command, where

subnet/mask is an IP address in dotted decimal format (A.B.C.D) and a

subnet mask that defines the in-band management network.

FTOS(conf)# ip route 10.1.1.0/24 vlan 1

11 (CLI only) By default, broadcast storm control is enabled on an Aggregator

to limit unregistered unicast, multicast, and broadcast packets. To disable

storm control, enter the following command:

FTOS(conf)# no io-aggregator broadcast storm-control

12 (CLI only) By default, IGMP multicast flooding is enabled on an

Aggregator. To disable multicast flooding to send unregistered multicast

packets only to interested hosts in a VLAN, enter the following command:

FTOS(conf)# no ip igmp snooping flood

Installing and Configuring the Aggregator