Allmatic B.RO MINI 1CH Manuel

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Allmatic B.RO MINI 1CH. Allmatic B.RO MINI 1CH 2 pages. Programmable radio receiver, single relay output.
Également pour Allmatic B.RO MINI 1CH : Manuel (8 pages)

Imprimer la page

DESCRIPTION

Miniaturize receiver Rolling Code, 1 channel with dry contact relay output 1A a 30 Vdc / 0.5A a 42.4 Vac.

Power supply 12-24 Vac/dc, frequency 433.92Mhz.

SignalingLED

Learning button

Selector for power

supply

LEARNING OF TRANSMITTERS

1. Select the power supply with the jumper and power up the receiver.

2. Press the learning button. The LED will light up.

3. Press the button of the transmitter you want to memorize. The LED will blink 2 times for the correct learning.

Repeat the procedure to memorize other transmitters.

The receiver memorize only one button for every transmitter. In case of learning of a second button of the same

transmitter, the receiver will remove the first button learnt.

MODALITY AND SELECTION OF THE FUNCTIONING

The functioning modalities of the relay are two::

1. IMMEDIATE: the relay is active as long as the radio signal is it as well, and the relay output is closed as long

the transmitter button is pressed.

2. ON TIME: the relay, once activated, is active for a programmable time from 1 seconds up to 60 seconds.

In order of selecting the required functioning modality, proceed as follow:

1. Press and keep pressed the learning button for more than 10 seconds.

2. When the LED blinks fast, it is possible to release the button. In this moment the time is set to 0 seconds

(immediate functioning).

3. Press and release the learning button to increase the time of activation of the relay. Each time you press

and subsequent release, the LED blinks one time and the time is increased by 1 second, until a maximum

of 60 seconds.

4. Press and keep pressed the learning button for more than 5 seconds.

5. When the LED blinks, it is possible to release the button. The time has been memorized.

During phase 3, after 20 seconds of inactivity, the receiver exits from the function, by timeout, without

saving settings and it will be set the immediate functioning.

6-1620051

rev5

B.RO MINI 1CH

Antenna

Radio module

12-24

Vac/dc

ITA

ENG

02/10/2020

Code

Max transmitters

Power supply

Consumption

Channels

Frequency

Unobstructed range

Relay contact

Temperature

*The range is influenced by the type of transmitter, antenna and

radio interferences

FRA

ESP

DEU

POR

Rolling Code

1000

12-24 Vac/Vdc

45mA dc - 85mA ac @12V

50mA dc - 100mA ac @24V

1 (immediate or on time)

433.92 MHz

80-250 m*

1A a 30 Vdc / 0.5A a 42.4 Vac

-10 ... +55°C

1/2