ABB ACQ580-585A-4 Manuel d'installation rapide - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} ABB ACQ580-585A-4. ABB ACQ580-585A-4 20 pages.

EN – Quick installation guide

Contents of this guide

This guide tells you briefly how to install the drive module into a 600 mm wide cabinet.

For installation examples in different cabinets and more detailed instructions, engineering

guide lines, technical data and complete safety instructions, see the hardware manual

(www.abb.com/drives:

Select Document Library and search for document number

3AXD50000048677 [English]).

Obey the safety instructions

See figure

on page 15. If you ignore these instructions, injury or death, or damage to the

equipment can occur.

WARNING! Handle the drive module carefully. Open the support legs by pressing

each leg a little down and turning it aside (1, 2).

Do not tilt the drive module. It is heavy and its center of gravity is high. The

module will overturn from a sideways tilt of 5 degrees. Do not leave the module

unattended on a sloping floor.

To prevent the drive module from falling, attach its top lifting lugs with chains to the cabinet

frame before you push the module into the cabinet. Work carefully preferably with help

from another person. Keep a constant pressure with one foot on the base of the module to

prevent the module from falling on its back.

WARNING! If you are not a qualified electrician, do not do installation or

maintenance work. Go through these steps before you begin any installation or

maintenance work.

1. Clearly identify the work location.

2. Disconnect all possible voltage sources.

•

Open the main disconnector of the drive.

•

Open the disconnector of the supply transformer as the main disconnector of the

drive does not remove the voltage from the input busbars of the drive.

•

Make sure that reconnection is not possible. Lock the disconnectors to open

position and attach a warning notice to them.

•

Disconnect any external power sources from the control circuits before you do

work on the control cables.

•

After you disconnect the drive, always wait for 5 minutes to let the intermediate

circuit capacitors discharge before you continue.

3. Protect any other energized parts in the work location against contact.

4. Take special precautions when close to bare conductors.

EN – Quick installation guide 9

3AXD50000048678 A